Are you looking for how to refill dancing water speakers but not getting enough information to start the process? Followed a guide on the internet but was still confused about the instruction given. This article will discuss the refilling process and how to clean water from speaker.
Refilling is straightforward; you can do it yourself and only need to remove the bottom water plug. These dancing speakers tend to leak water through this plug. But no need to worry because this guide will show you how to take the speakers apart and then change the water plug with super glue.
How To Open Dancing Water Speakers and Refill Them? (7 Easy way)
It is straightforward to refill the water dancing speakers. The refilling process is below; you can also use it to clean the water from the speakers by following the dancing water speaker instructions.
1) Gather all Tools
You should have some essential things for a refill, like a clean workspace, super glue, water dancing speakers, a Phillips screwdriver, and mineral water.
2) Unplug the Power Source
First, remove the power source, and unplug the USB cable. It is essential before starting the process of refilling.
3) Unscrew the Bottom Part
Use the Phillips screwdriver to remove the four screws on the bottom of the speakers.
4) Remove the Bottom Part
After taking out these four screws, slide the bottom part from the water container when you separate both parts, and then place the bottom facing up.
5) Refill the Speakers
There will be a hole at the bottom of the water canister. It is the place from where you can insert water into the dancing speakers. Remove the black plug covering the hole by using the screwdriver. After plugging out the black cover, refill the speakers. Remember that only refill the speakers with one inch of water.
6) Seal with Super Glue
Once you refill the water up to one inch, close the hole using super glue and let it dry.
7) Tighten the Screws
Slide the speakers back on the water container when the glue dries. After this, place the back panel on and tighten it with the four screws. Use the same above step for the second dancing water speaker. After this, your speakers are ready to use.
Guitar Speakers: For High Gain and Clean Tone
Ultimate Guide: How To Enable Monitor Speakers?
Dancing speakers do have a separate container for the water. Most people confuse its structure and think it is submerged in water with all its circuits and vital components. However, it is not true. These speakers have water, but the main parts are not in direct contact with the water, making them work flawlessly.
It is easy to put water in dancing water speakers. For this, you will see a hole in the bottom of the water container. Remove the black plug covering and pry it out by using the screwdriver. Once you remove the plug, put water into the dancing water speakers. Remember to seal the bottom with super glue after refilling to prevent leakage.
Use the USB cable and connect both speakers when you hook up the speakers, then go ahead and touch the button on the bottom so it will turn on. Then choose a mode, and it will be beyond waiting for Perry. Although the process is straightforward, you can face difficulty connecting the speakers. For this, following the troubleshooting guidelines from the manufacturer can help.
To charge the Goodman water speakers, use the included USB and insert it into the USB port on the water speakers. Then connect the other end to the USB port of your computer, and you can use the 5V 1A USB wall charger for charging instead of the computer port. However, the wall charger is not included. When the charging of speakers is complete, the LED indicator will become RED.
Setting up the dancing water speakers is straightforward. They are easy to connect with the devices using Bluetooth connection. Turn on Bluetooth on your devices and enable pairing. After successful pairing, you can use the speakers using Bluetooth. If you cannot set up the speakers using Bluetooth, try changing the source or using a USB connection.
Cleaning dancing water speakers is necessary as the water can turn the inside foggy and give an unpleasant view. First, use the instructions above to empty the water inside the speakers. Then use any super cleaner available in the market to rinse the inside of the speakers. You can use a thin brush to get assistance. Once all the fogginess clears, you can refill and put the speakers back together.
